potentiometer Hi hat problem.

Discussions related to MegaDrum Hardware

potentiometer Hi hat problem.

Postby Effraktor » Thu Apr 08, 2010 9:46 pm

Hey. finaly got my zendrum/megadrum playably finished. Jutst trying to set somethings up and i've noticed a few problems. Thought i'd see if anyone has any ideas.

On the lcd the hi hat level bar goes to full when my pot is less than half way slid up. Below that it responds normaly and the bar goes up and down ok.

But in the megadrum config software in the midi monitor section it doesn't show anything in the hihat open----closed section.

I do get a midi responce of 0 from the hi hat pad when the pot is on anything below full. then when it show sup as full on the lcd it changes to midi note 3. So i am getting a variance. But i thought i should be able to get atleast 3 different positions and a chick sound?

it's a 100k pot so i attatched it to the high impedance wire and have put the settings to altin to yes.
Effraktor
 
Posts: 43
Joined: Tue Nov 24, 2009 1:44 am

Re: potentiometer Hi hat problem.

Postby dmitri » Thu Apr 08, 2010 9:57 pm

Effraktor wrote:Hey. finaly got my zendrum/megadrum playably finished. Jutst trying to set somethings up and i've noticed a few problems. Thought i'd see if anyone has any ideas.

On the lcd the hi hat level bar goes to full when my pot is less than half way slid up. Below that it responds normaly and the bar goes up and down ok.

1. Adjust Low and HighLevel in pedal settins.
2. Limit physical range of the resistor.
3. Add a resistor to the +5V end of the potentiometer to limit voltage swing to less then 5V.


But in the megadrum config software in the midi monitor section it doesn't show anything in the hihat open----closed section.

I do get a midi responce of 0 from the hi hat pad when the pot is on anything below full. then when it show sup as full on the lcd it changes to midi note 3. So i am getting a variance. But i thought i should be able to get atleast 3 different positions and a chick sound?

it's a 100k pot so i attatched it to the high impedance wire and have put the settings to altin to yes.

Set Pedal type to F.Contr
dmitri
Site Admin
 
Posts: 8709
Joined: Fri Aug 03, 2007 8:05 pm

Re: potentiometer Hi hat problem.

Postby Ken Forgettable » Sat Apr 10, 2010 1:33 am

2. Limit physical range of the resistor.

Change the overall resistance of the carbon track - double speek for using less pot.
Ken Forgettable
 
Posts: 402
Joined: Tue Jan 06, 2009 5:04 pm


Return to MegaDrum Hardware

Who is online

Users browsing this forum: Google [Bot] and 92 guests