Probleme with Note number.

[dmitri]

If RHH-135's schematic is the same as in http://www.toontrack.com/forum/tm.aspx?m=35256 then:
1. It is a high impedance pedal and must be used on the High impedance pedal input with AltIn set to Yes.
2. Sleeve is ground, Ring is for power and Tip is for signal.
3. It has only five levels of openness so is not fully variable.
4. LowLevel/HiLevel must be properly set to get it working. Starting values to play with can be set using LevelsAuto set to Yes, setting LowLevel/HighLevel to 299/300 and then pressing the pedal a few times (you may need to try different starting values for LowLevel/HiLevel instead of 299/300). After levels were automatically set, LevelsAuto must be set to No and LowLevel/HiLevel should be fine tuned.

[Bulok]

Oki, thx you for your help ...

I have finish to configure it ..

but now, i have just 1 pb :

it's not stable ...
1 video for explication ( no sound sorry ^^ )

http://www.youtube.com/watch?v=PcPRsUMn_-0

[dmitri]

it's not stable ...
1 video for explication ( no sound sorry ^^ )

http://www.youtube.com/watch?v=PcPRsUMn_-0

What is not stable?
What problem should I see in the video?

[Bulok]

I could not explain decently, I am really too bad in English.

I redid another video with the sound, I hope you will understand a little better what that gives.

http://www.youtube.com/watch?v=TKMpXGFaqno

[dmitri]

I still don't get exactly what you are trying to show. Especially so without explaining:
1. what pedal you are using.
2. what settings you've set.
3. how you've set these settings.
4. what you are doing with the pedal.

[Bulok]

Hi

My config :




And video with hit-hat and screen.

http://www.youtube.com/watch?v=ih0zXiBW12k

I am going to try to explain.

The hit-hat works correctly at the level opened / closed as well as different stages.

But it does not remain stable (it varies between opened and opened 1/2).
Thus it detects non-stop knocks.

When it is closed, it works trés indeed.
But if it is correctly opened, I tap a pad and it begins trembling.


I send Jdigdug for give me her setting ^^.

[dmitri]

You have missed 1 and 3

I still don't get exactly what you are trying to show. Especially so without explaining:
1. what pedal you are using.
2. what settings you've set.
3. how you've set these settings.
4. what you are doing with the pedal.

[Bulok]

It's just standar pedal :


With RHH-135 hit hat :

[dmitri]

Did you read through one of my previous posts: viewtopic.php?p=15063#p15063?
And in particular about High impedance input and AltIn setting?
And you still missed point 3 about how you arrived at the LowLevel/HiLevel and OpenLevel/Closed level.

[Bulok]

Hi

i have jdigdug setting, and it's not working for me ....

I think it's my socket connector not correctly connected :p ...