PCB Inputs Jacks v1.8 for All In One PCB v2.8

[jman 31]

Me and my friend just started building a MegaDrum and are still looking for parts.
Is there anyone who could make us a two sets of these input PCBs?
If you could make us a set just sent me a PM.

Thanks in advance.

I've got one set etched and ready to drill. I would trade them for the necessary stereo jacks for this board. PM me if you are interested.

Jman

[anirudh.pianist]

Ther are 2 32pin input connector in these jacks pcb...but only 1 in the main all in 1 board....wer to connect all?From 1 32 pin wire there will be place for 2 of these slots to fit?should i use this concept?

Bye,
ANI

[Russ15]

Would anyone happen to have the exact dimensions of the pcb input jacks v1.8 pdf located here? viewtopic.php?p=5593#p5593

Thanks!

[4-raldo]

Hello. Will it work charge Jack v1.8 channels All in One PCB v2.5 Synthax ?

[dmitri]

I always wondered why people wanted to have a PCB for jacks. Why won't you solder wires directly to jacks?

[4-raldo]

I always wondered why people wanted to have a PCB for jacks. Why won't you solder wires directly to jacks?

Hello dmitri.
Because accuracy is the key to success. If sculpt wires, it is possible to get confused and make mistakes in the connection. On the circuit Board to make some errors more difficult (if again the same be done carefully). Although the manufacture of printed circuit boards takes some time, still it is much more convenient than using wires. IMHO

Question about PCB v2.5 and Jack PCB v1.8 left.