SysEx chain ID problem

[Renzback]

Hello!

Whenever I turn my MegaDrum module on, the module is set with the SysEx Chain ID = 255… This is weird, as you are not supposed to go over 127 in the first place… I always have to manually set it back to zero on the module itself so it can communicate with the Megadrum Manager FX… Any hint how I can store value zero permanently in the module? I can’t seem to find a way even though I wait a few seconds before changing pages, until the module says “config saved”. Not very important but a bit annoying…

Thanks in advance if you have the answer!
Cheers!
Renaud

PS: I just saw there is a recent firmware update, I’ll try that in the next few days.

[ignotus]

Set Autoload Conf to 'Yes' (in the module's menu)

[Renzback]

Set Autoload Conf to 'Yes' (in the module's menu)

Hi
Thanks for the hint. I already have this setting active. I will try and update the firmware over the weekend.