www.megadrum.info

Hi,

im going crazy to wire my stereo audio jacks with the pad connector on the pcb Synthex v2.8.

here is a link to my jack-schematic.

https://service.gmx.net/de/cgi/derefer? ... 54e341b204

Can anybody give an example how to wire (e.g. the kick drum) from the jack to the pad connector. Which pin from the jack to which pin to the pad connector.

Hope anyone give me an example - so i understand the wiring.

thanx a lot.....

I am not sure what you are asking, but it looks like Pin 1 is the sleeve, 2 is the ring and 3 is the tip. It's pretty self explanatory. Sleeve is almost always ground. Ring and tip don't really matter as much since they are for two zones. Tip will be one zone or pad and ring will be the other. Both will use the sleeve for their ground.

On the synthex version of jacks board..ther 2 two jacks board rite?then on the main PCB there is only place for 1 connector for jacks?where/how to connect the other 1 to the main PCB?
THANK U

Bye,
Anirudh