MIDI IN silences all Megadrum inputs
Posted: Sun Jul 31, 2011 8:27 amHi All,
Haven't been on here for a long time now. I've been playing my real drumkit and the electronic kit has been in the corner for a while.
I am building a new kit to start using them again and I bought another Megadrum of EBay (with Rotary encoders 644/20 which Dmitri built) so now I have two MDs!
All pads (snare/toms) are connected to a TD12 and a midi cable is connected to the new MD MIDI IN from the TD12 Midi OUT. All my cymbal are connected to the Megadrum and MIDI Thru is enabled. From here the MD feeds into my laptop thru USB. When the TD12 is turned on and midi connection is established the MD pads stop responding. there is no activity shown on the MD display. The MIDI thru is working as the TD12 pads are sent thru to the Laptop to Superior II. If I unplug the lead or turnoff the TD12 the MD starts responding again.
New MD is on latest firmware (20110719) and I have tried changing midi speed. TD12 will only work on USB+Midi as on other modes it says that communication is lost.
I have reset the new MD and reinstalled the firmware.
My other MD is on a pre protected bootloader firmware (The last one before positional sensing was implemented) and it works fine with the TD12 and MD hooked up together.
Not sure if this is a hardware or firmware fault.
Thanks
Haven't been on here for a long time now. I've been playing my real drumkit and the electronic kit has been in the corner for a while.
I am building a new kit to start using them again and I bought another Megadrum of EBay (with Rotary encoders 644/20 which Dmitri built) so now I have two MDs!
All pads (snare/toms) are connected to a TD12 and a midi cable is connected to the new MD MIDI IN from the TD12 Midi OUT. All my cymbal are connected to the Megadrum and MIDI Thru is enabled. From here the MD feeds into my laptop thru USB. When the TD12 is turned on and midi connection is established the MD pads stop responding. there is no activity shown on the MD display. The MIDI thru is working as the TD12 pads are sent thru to the Laptop to Superior II. If I unplug the lead or turnoff the TD12 the MD starts responding again.
New MD is on latest firmware (20110719) and I have tried changing midi speed. TD12 will only work on USB+Midi as on other modes it says that communication is lost.
I have reset the new MD and reinstalled the firmware.
My other MD is on a pre protected bootloader firmware (The last one before positional sensing was implemented) and it works fine with the TD12 and MD hooked up together.
Not sure if this is a hardware or firmware fault.
Thanks