www.megadrum.info

Hi. Im allmost done building. I must say I was quite anxious when I started. The result is that I built Synthex's old digital and usb board (cause I couldnt find the IC's) and megaanalogue2 as analogue board. What am I doing? Is this possible? can I use that analogue board and only that? Which firmware should I use?

Thank you all.

PS: Remember my spanish translation offer? When you have updated the manual just let me know.

You made me a little confused. What boards did you build exactly? If it's Synthex's PCB than it should be both Digital and Analogue boards in one and obviously you don't need to connect them together. If you used PCBs which I designed than for 32 inputs you need to use 1 Digital board and 2 Analogue boards and connect them all together with one flat cable. Firmware version doesn't depend on PCB version. It depends on Atmega IC type, Crystal frequency and number of inputs.

You talk about this digital PCB ?
http://www.megadrum.info/forums/viewtopic.php?f=3&t=88&start=0&st=0&sk=t&sd=a#p815

YES! Thats correct, I used THAT PCB. And built megaanalogue2 by dimitri. Just dont know if megaanalogue and megaanalogue2 are the same thing, or just the first and second analogue boards. Thanks for your help - again.

el_fela wrote:YES! Thats correct, I used THAT PCB. And built megaanalogue2 by dimitri. Just dont know if megaanalogue and megaanalogue2 are the same thing, or just the first and second analogue boards. Thanks for your help - again.

megadrumanalogue is for 22 inputs version.You will need only one of this, if you want 22 inputs.
megadrumanalogue2 is for 32 inputs version. You will need two of these for 32 inputs.