www.megadrum.info

Posted: **Thu Jan 10, 2013 11:41 am**

Hi,

i´ve got an E-Drum Set from Dave with Roland Cymbals and HH, will the Megadrum work well with these Pads ?
I read something about too hot Signals from these Triggers.

Kind regards

Posted: **Thu Jan 10, 2013 1:41 pm**

You`ll probably need resistors or pots added, to cool the signal down.
Other then that, I`m pretty sure they will work great once you set them in the MD.

Posted: **Fri Jan 11, 2013 2:32 pm**

Is not a problem,

the most of the pad need to cooled with voltage divider

Roland Cymbal pad works very well, have been tested by several users ( also yamaha pad )

Posted: **Fri Jan 11, 2013 7:15 pm**

Check my list...there you see some Roland stuff and if a resistor was required.

http://powerhell.wordpress.com/about/zo ... d-library/

Angr77

Posted: **Sun Jan 13, 2013 11:33 am**

Thanks, I wasn't too concerned about the Roland Gear.

Won't the Voltage Dividers result in lower dynamics ?

Posted: **Sun Jan 13, 2013 12:28 pm**

stickprick wrote:Won't the Voltage Dividers result in lower dynamics ?

No. In fact with too "hot" pads voltage dividers improve dynamics.

www.megadrum.info

Will this work with a Diamond Electronic Drumset ?

Will this work with a Diamond Electronic Drumset ?

Re: Will this work with a Diamond Electronic Drumset ?

Re: Will this work with a Diamond Electronic Drumset ?

Re: Will this work with a Diamond Electronic Drumset ?

Re: Will this work with a Diamond Electronic Drumset ?

Re: Will this work with a Diamond Electronic Drumset ?