www.megadrum.info

by **marcjwebbmusic** » Sat May 18, 2013 9:45 am

I have now built my megadrum and all I have left to do is the input jacks. So out of curiosity and to make sure it was working unturned it on but noticed that the first bar on the 16x2 is always up high. Has anyone else had this and what did you do to change it.

If you have any info please share.

Marc

by **dmitri** » Sat May 18, 2013 1:20 pm

Please see viewtopic.php?p=23998#p23998

by **marcjwebbmusic** » Sat May 18, 2013 1:53 pm

There is no reply there ?? Am confused a little

by **ignotus** » Sat May 18, 2013 7:42 pm

Stop worrying, it's normal. Your module just thinks you have a fully open hi hat pedal. Until you configure it with an actual pedal plugged in don't bother yourself with that.

by **marcjwebbmusic** » Sat May 18, 2013 9:29 pm

Awesome cheers buddy. One other quick question. I would like I use two rotary encoders with 2 switches. However the schematics sjow both the buttons separate from the encoders but I have seen people using 2 of each any input here ?

Marc

by **dmitri** » Sat May 18, 2013 10:46 pm

I use rotary encoders with built-in switches.

by **marcjwebbmusic** » Sat May 18, 2013 10:51 pm

Yeah that's the ones I have. Is it just a case of wiring the side that has 2 pins to where the button would be ?

by **dmitri** » Sun May 19, 2013 12:00 pm

www.megadrum.info

Always high level on first VU when turn on

Always high level on first VU when turn on

Re: Always high level on first VU when turn on

Re: Always high level on first VU when turn on

Re: Always high level on first VU when turn on

Re: Always high level on first VU when turn on

Re: Always high level on first VU when turn on

Re: Always high level on first VU when turn on

Re: Always high level on first VU when turn on

Who is online