Page 1 of 1
Always high level on first VU when turn on
Posted:
Sat May 18, 2013 9:45 amby marcjwebbmusic
I have now built my megadrum and all I have left to do is the input jacks. So out of curiosity and to make sure it was working unturned it on but noticed that the first bar on the 16x2 is always up high. Has anyone else had this and what did you do to change it.
If you have any info please share.
Marc
Re: Always high level on first VU when turn on
Posted:
Sat May 18, 2013 1:20 pmby dmitri
Re: Always high level on first VU when turn on
Posted:
Sat May 18, 2013 1:53 pmby marcjwebbmusic
There is no reply there ?? Am confused a little
Re: Always high level on first VU when turn on
Posted:
Sat May 18, 2013 7:42 pmby ignotus
Stop worrying, it's normal. Your module just thinks you have a fully open hi hat pedal. Until you configure it with an actual pedal plugged in don't bother yourself with that.
Re: Always high level on first VU when turn on
Posted:
Sat May 18, 2013 9:29 pmby marcjwebbmusic
Awesome cheers buddy. One other quick question. I would like I use two rotary encoders with 2 switches. However the schematics sjow both the buttons separate from the encoders but I have seen people using 2 of each any input here ?
Marc
Re: Always high level on first VU when turn on
Posted:
Sat May 18, 2013 10:46 pmby dmitri
I use rotary encoders with built-in switches.
Re: Always high level on first VU when turn on
Posted:
Sat May 18, 2013 10:51 pmby marcjwebbmusic
Yeah that's the ones I have. Is it just a case of wiring the side that has 2 pins to where the button would be ?
Re: Always high level on first VU when turn on
Posted:
Sun May 19, 2013 12:00 pmby dmitri
Yes