www.megadrum.info

1. I have a normal standard hi hat and roland cy5 (1 piece). Under cy5 i have device which measure level (height) of that cy-5. I don’t use any Roland controller. So I should set Hi-hat as Pot, not as a F.Contr. Is is right ?
2. Due to the fact that it is POT and not F.CONT i understand that I shouldn’t touch any settings describe in your manual from following chapters ?

3.5
3.6
3.12
3.13
3.14
3.15

Rest of points concern POT (Potenciometr). Is it OK ?

3. I understand that values set in mentioned points has no REAL INFLUENCE for other setting – till i use POT and not use F.CONTR


For everyone comfort, here you have full list of hi hat chapters:

3 HiHat Pedal settings
3.1 Set HiHat Pedal Type
Type: F.Contr
Type: Pot
3.2 Set HiHat Pedal Curve
Curve: Linear
3.3 Set HiHat Pedal Chick Delay
ChckDelay: 0
3.4 Set HiHat Pedal Impedance
AltIn: No
3.5 Set HiHat Pedal Control Change Value
CC Value: 4
3.6 Set HiHat Pedal Control Change Reduction Level
CC RdcLvl: 0
3.7 Reverse HiHat Pedal Levels
LvlsRevers: No
3.8 Enable HiHat Soft Chicks
EnSoftChick: No
3.9 HiHat Pedal Auto Adjust
LevelsAuto: Yes
3.10 Set HiHat Pedal Low Level
LowLevel: 90
3.11 Set HiHat Pedal High Level
HiLevel: 900
3.12 Set HiHat Pedal Open Levels
OpenLvl: 8
3.13 Set HiHat Pedal Closed Level
3.14 Set HiHat Pedal Short Chick Level
ShrtChckTh 115
3.15 Set HiHat Pedal Long Chick Level
LngChckTh: 16
3.16 Combine HiHat Pedal With HiHat Cymbal Input
HHInput: 2
3.17 HiHat Pedal Note Number Settings
BowSO: G1 44
BowHO: G1 44
BowSCL:G1 44
BowCL: G1 44
Chick: F#2 42
Splsh: A#2 46

You should really read documentation before posting questions. In http://www.megadrum.info/content/hihat-pedal-settings it says:

<HiHat Pedal >
Type: F.Contr

<HiHat Pedal >
Type: Pot

Set the type of the HiHat pedal. The only difference, at the moment , is that when it set to F.Contr (Foot Controller) MegaDrum send Control Change (CC) messages with the changes of the pedal position. And when it is set to Pot (Potentiometer) it doesn't send CC messages.