www.megadrum.info

Hello maybe someone can help me.
I set my Pad CY-13R and all areas of the pad work well, but only with the chocke pressing the Bell area.
I've tried to reconfigure all forms and can not engage the choke on Edge zone.
I have a 56 Channel ARM based Full kit with extended EEPROM with the optional positional sensing add-on board
firmware megadrumSTM32d_56_20160406
I checked even the cables to see if there was something inverted.
Does anyone have any suggestions?
Thank you.

First see http://www.megadrum.info/forums/viewtop ... f=3&t=1968

Make sure the Bow/Bell cable is connected to the first of the cymbal jacks and the Bow/Edge cable is connected to the next jack.
Post screenshots of your settings for the cymbal and give a bit more description of the problem.