www.megadrum.info

Dmitri, could you please take a look at this and if it's not a configuration problem could you please let me know what to check on the hardware side?

Short explanation: I'm trying to fine adjust the toms; I had this separation problem with the Small Tom... Then I copied the parameters of input 6-7 to input 8-9 (except the note numbers) and used the same cable / trigger / tom (basically I moved TRS jack from in 6-7 to the next input) and I got good results.





Thank you!

...and with Rim Threshold=120...

You have to fine tune MidPoint for best zone separation on a dual piezo/piezo pad.

Hi Dmitri!

Already tried that...

Any reason why the crosstalk level is at 0?

Hi Angr!

No, but I'm working on a single pad now, I didn't assemble the whole drum kit yet... But I thought if it's ok for the other input... Anyway, I will give it a shot...

Default is 4 for group 0, right?

Yep, I was right...

You also have to make sure that HighLevel is set correctly for both zones. After that you have to adjust the MidPoint. How did you set HighLevels?

As per instructions:



I left intentionally for the purpose of the screenshot the High Auto Levels to on, I want to cool down the Rim Piezo...

The point is that on the next input (8-9) with the same setting it is working fine... (of course, same pad, same trigger, same cable)...

Maybe it's not clear in the picture because the initial events went away... I will redo...