Page 1 of 1
Hi hat wiring
Posted:
Wed Jun 10, 2020 12:27 pmby airflamesred
Refurbing this Alesis dm6
The hi hat is mono so fine.
The pedal seems to offer a variable resistance of 147 open and 0.1 closed.
It's mono so which pins do I wire this to?
Thanks
Re: Hi hat wiring
Posted:
Fri Jun 12, 2020 7:50 amby airflamesred
Bump
Re: Hi hat wiring
Posted:
Fri Jun 12, 2020 10:51 amby ignotus
I'd assume you'd wire it to tip and sleeve.
Re: Hi hat wiring
Posted:
Fri Jun 12, 2020 11:19 amby airflamesred
Cheers mate, so do I need pin 40 (pedal power)?
And either low or high impedance?
Re: Hi hat wiring
Posted:
Fri Jun 12, 2020 11:27 amby ignotus
If it's a mono jack I don't see how you can power it. I'd say it's low impedance if it just goes up to 147 ohms.
I'm not sure if the module requires there to be a voltage applied though, or if can just work with a varying resistance.
Re: Hi hat wiring
Posted:
Fri Jun 12, 2020 11:59 amby airflamesred
Well the module is now going to be MD so however they wired it will remain a mystery. I'm planning on running this in a DAW so do you think this could be adapted to change the value of CC4 for example.
Re: Hi hat wiring
Posted:
Fri Jun 12, 2020 12:47 pmby ignotus
If MD can register the changes in pedal position then there's nothing stopping it from sending CC data.