www.megadrum.info

i did it.

bought a pc for the sole purpose of updating firmware via midi-ox, and to control the MD via MCT.

works



but how is the MIDI-in/out cable wired to the MD ?

it doesn't work for me.

i get loud static bursts or noise when the midi cable (which is checked & working btw ) is connected to my DAW (Digi 002).

and the MegaDrum's LCD also flashed on/off when a note is hit....?!
this is how i did it (via Synthex's Quick Manual)

MIDI IN OUT Connector :

1 - MIDI OUT + (DIN pin 4)
2 - MIDI OUT - (DIN pin 5)
3 - MIDI OUT GND (DIN pin 2)
4 - MIDI IN + (DIN pin 4)
5 - MIDI IN - (DIN pin 5)

so pins 1 and 3 on the female midi output are not used.
correct, no?

ole_hansen wrote:so pins 1 and 3 on the female midi output are not used.
correct, no?

Yes.
And pin 2 on MIDI IN is not used too.

http://pinouts.ru/Home/MidiIn_pinout.shtml
http://pinouts.ru/Home/MidiOut_pinout.shtml

To be sure, you connect :
Megadrum MIDI OUT -> Digi002 MIDI IN
Digi002 MIDI OUT -> Megadrum MIDI IN

i have soldered it correctly.

NO i'm a TOTAL freakin idiot!
i wired everything to ONE midi connector...
wow Ole - a "midi in/out connection" ? wow - that's impressive....
i'm such a f*cktard....

Be careful, you can burn all your hardware