www.megadrum.info

Hello,

Is this normal that each individual setting configuration affect overall inputs? I notice after i configure and done each pad settings perfectly and click send all , the tom 1, snare and ride malfunction and not be accurate even i set it perfectly before and save it syx files individually. Thanks

No, it is not not normal. Before clicking 'Send All' check that settings in MDMFX for tom1, snare and ride as you you configured them previously. Also make sure all Misc settings are as when you configured tom1, snare and ride.

But what is the problem? i check it and configure it by using fx manager. All toms are same pads and same configure, all cyms pads are same and same configured, and its works perfect but when all configuration are send all to module that bugs happen.

I don't exactly understand what you are actually doing to break the configuration.
What I can suggest is:
1. When everything is configured perfectly, do 'Get All' - that way MDMFX get an exact copy of the config in MegaDrum.
2. After that do 'Send All'.
Is configuration in MegaDrum broken after that?

That exactly how i do it. Get all then send all also save to slot 1 after then close midi. But after that the ride has not triggering, the tom 1 has not responsive than tom 2 and tom 3 even its same configuration. The snare affected also. Did i do wrong ? I check my wiring and its right using your diagram. Can you check my mds file to your megadrum lite board? I will send.

heres my configuration mds file

rendelbello18 wrote:That exactly how i do it. Get all then send all also save to slot 1 after then close midi

This is not exactly what I advised you to do.
1. When everything is configured perfectly, do 'Get All' - that way MDMFX get an exact copy of the config in MegaDrum.
2. After that do just 'Send All'. Not 'Send All' and Save to Slot 1. Not close MIDI. Not anything else.
Is configuration in MegaDrum broken after that?

Yes i tried but same issue.

what do you mean broken?

It just make no sense.
When you do 'Get All' first and then do 'Send All' no config changes are made inside MegaDrum so there cannot be changes in behaviour.
Let's focus on Ride.
1. When everything is configured perfectly, do 'Get All' - that way MDMFX get an exact copy of the config in MegaDrum.
2. Is Ride still working?
3. Take a screenshot of MDMFX showing Ride settings.
4. After that do just 'Send All'.
5. Is Ride broken?
6. Take a screenshot of MDMFX showing Ride settings again.