Problem with AutoLoadConfig

[thramul]

Hello,
I have successfully build my megadrum, and most things are working fine so far. But I seem to have a problem with the setting "AutoLoadConfig". When I turn in on (and wait until the menu closes) and reboot, it loads the last config as wanted. But if I now check the setting again, its set on "no" again, therefore not loading the last config upon the next reboot. Do I missunderstand the functionality of this parameter, or do I have a problem here? If so - how can I solve this?
I have build synthex kit 3, with Atmega 32 and 16mhz clock.
Thanks!
Greetings,
Matthias

[dmitri]

What version of the firmware do you have?

[thramul]

I have the firmware 20090211.

[dmitri]

From the change log at http://www.megadrum.info/forums/viewtopic.php?f=3&t=58

Changes in 20090326 version:

1. Made 'Autoload Conf' option consistent. MIDI Speed is now saved/loaded into/from config slots along with all other settings.
2. Fixed loading default settings with the key RIGHT pressed while powering up.
...
Changes in 20090301 version:

1. Fixed displaying incorrect 'AutoLoad Conf'. It always displayed 'No' on power up even if it was set to 'Yes'.

[thramul]

ah ok, that solves this one. Thank you Now I just have to get the MCT send function working, so I can update the firmware.

[dmitri]

Don't use MCT to update firmware: http://www.megadrum.info/forums/viewtop ... 7909#p7909
Use MIDI-OX instead: http://www.megadrum.info/forums/viewtopic.php?f=3&t=622