Hi-hat pedal for silent kick trigger supported?

[Andrej]

For making a very quiet kit, I'd like to use a hi-hat controller for triggering the bass drum.
Something like using a Yamaha RHH135 with the new DTX700 module.

Does Megadrum support this? If so, what HH pedal would be recommended?

Thank you
Andrej

[dmitri]

Set the pedal's Chick note to the Kick's note and there you go. Or am I missing something?

[Andrej]

[quote="dmitri"]Set the pedal's Chick note to the Kick's note and there you go. Or am I missing something?[/quote]

Maybe. Looking at the pre-built megadrum module, only one input has the label HH. And looking at the schematics,
the [Pads Connector Pinout]#1 (HH Pedal Ring) is connected to VCC over a resistor. But, only
that pin is. So I assumed I might only be able to connect one HH pedal.

I could change the pads connector pinout, and add two more pins to VCC over a resistor. But will the frameware
support this?

Basically, I want to use up to three HH pedals. One for HH, and two for Kick. (I live in an apartment, that's why I want
to avoid Kick drums pedals).

Thx
Andrej

[dmitri]

At the moment only one HiHat pedal is supported. It may change in the future.

[Andrej]

At the moment only one HiHat pedal is supported. It may change in the future.

Thanks Dmitri for your fast response. That's what I feared.

I'm a beginner, not even sure if I need to do this.

Thank you
Andrej

[everson]

Just saw this ...
I think the perfect solution for these kind of requests is krigg - kick pedal trigger.
I have 2 of them ...

[airflamesred]

or, if you're not worried about velocity there are some roland pedals .
http://www.ebay.co.uk/itm/Roland-DP-2-D ... 867wt_1159.