set up config for Yahaha hh65

Discussions related to MegaDrum Hardware

set up config for Yahaha hh65

Postby cooper61uk » Wed Aug 31, 2011 5:30 am

Hi guys as a total newbe to MD i was wondering wether i can use hh65 as a hh pedal and if so the various settings in the config to set it too.
Help would be much welcome
John
cooper61uk
 
Posts: 6
Joined: Thu Nov 11, 2010 12:30 pm

Re: set up config for Yahaha hh65

Postby dmitri » Wed Aug 31, 2011 9:07 am

I'm pretty sure you can.
1. First check pedals polarity. If it is a Yamaha pedal than I suspect it uses power on the tip and signal on the ring so if you're using a module built by me than you need a cross over cable.
2. If it is a high impedance pedal, make sure you set the HiHat impedance switch accordingly and set AltIn to Yes.
3. Read http://www.megadrum.info/content/hihat-pedal-settings
4. Read viewtopic.php?f=3&t=972, it may be relevant.

After you've tried to set the pedal up and it still doesn't work, come back here and describe how you tried to set it up and configure and I will try to help.
dmitri
Site Admin
 
Posts: 8709
Joined: Fri Aug 03, 2007 8:05 pm

Re: set up config for Yahaha hh65

Postby Russ15 » Sun Sep 04, 2011 10:48 pm

Hey cooper61uk if you figure out the configuration couldf you post your findings? I am almost finished building my megadrum and am about to start buying cymbals and a hi hat controller. I'm debating on the hh65 or fd-7 or 8. Thanks
Russ15
 
Posts: 82
Joined: Sat Jul 09, 2011 8:22 pm


Return to MegaDrum Hardware

Who is online

Users browsing this forum: No registered users and 70 guests