Hi, does anybody has the hihat-pedal settings for a 100k poti? I connected the poti to the hihat-pedal jack but the hihat-indicator won't change no matter which settings I use
It's the last thing missing on my kit. Everything else works!
Tom
Tom wrote:no matter which settings I use
Tom wrote:I tried at least Poti/Foot Controller and Alternative Input On/Off and a bunch of low and high values.
Question of the day: Does the blue LED flash, if I change the value of the poti?
The MIDI LED flashes only when MIDI messages are being sent, e.g. CC (for position changes) or Note On (for for chick/splash) messages
Tom wrote:Hi dimitri,
thank you for your patienceThe MIDI LED flashes only when MIDI messages are being sent, e.g. CC (for position changes) or Note On (for for chick/splash) messages
Ah, ok. So if I use 'F.Contr' it should send CC messages (according to the documentation), but the LED doesn't flash.
For the wireing I used pretty much that one: http://edrums.gl.tter.org/ with a 100k poti.
Of course i'm using the Hihat Pedal jack.
In my understanding, the LED should flash (because of the cc messages) even if I use the wrong high and low parameters, right?
But nothing happens... Not sure if its a mistake in my configuration or if that poti solution simply doesn't work.
Low or high impedance input?
Is there voltage change on the pedal input when changing pot's position? What configuration settings did you use?
Tom wrote:Low or high impedance input?
Wow I feel really stupid now... I don't know Just bought http://www.produktinfo.conrad.com/datenblaetter/425000-449999/442188-da-01-en-SCHIEBEPOTENTIOMETER_RS60112_100KBX2.pdf this poti, wired it and wired it to a jack.
Is there voltage change on the pedal input when changing pot's position? What configuration settings did you use?
You mean on the inputboard?
Is the jack wired to a low or high impedance pedal input?
What inputboard?
Users browsing this forum: No registered users and 71 guests