dmitri wrote:The algorithm is meant for a cymbal/pad where piezo and switches are mechanically linked so that when one of the zones with a switch is hit the piezo also triggers.
Any suggestion about my last post in this thread Dmitri?
3 different informations to 1 input?
24 posts
• Page 3 of 3 • 1, 2, 3
Re: 3 different informations to 1 input?
by tinch06 » Sat Feb 04, 2017 3:45 pm
Any suggestion about my last post in this thread Dmitri?
- tinch06
- Posts: 10
- Joined: Fri Sep 02, 2016 11:51 pm
Re: 3 different informations to 1 input?
by dmitri » Sat Feb 04, 2017 4:17 pm
I can only suspect that you did not make the cymbal right, i.e. you did not add a 10k resistor on the edge switch.
- dmitri
- Site Admin
- Posts: 8706
- Joined: Fri Aug 03, 2007 8:05 pm
Re: 3 different informations to 1 input?
by tinch06 » Sat Feb 04, 2017 9:33 pm
dmitri wrote:I can only suspect that you did not make the cymbal right, i.e. you did not add a 10k resistor on the edge switch.
I have checked many times. Can I use a bigger resistor?
- tinch06
- Posts: 10
- Joined: Fri Sep 02, 2016 11:51 pm
Re: 3 different informations to 1 input?
by dmitri » Sun Feb 05, 2017 8:55 pm
1. What is the resistance between ring and sleeve when none of the switches pressed?
2. What is the resistance between ring and sleeve when the edge switch is pressed?
3. What is the resistance between ring and sleeve when the bell switch is pressed?
2. What is the resistance between ring and sleeve when the edge switch is pressed?
3. What is the resistance between ring and sleeve when the bell switch is pressed?
- dmitri
- Site Admin
- Posts: 8706
- Joined: Fri Aug 03, 2007 8:05 pm
24 posts
• Page 3 of 3 • 1, 2, 3
Who is online
Users browsing this forum: No registered users and 74 guests