Head-Rim Crosstalk problem on input 6-7

[maru_engineering]

Dmitri, could you please take a look at this and if it's not a configuration problem could you please let me know what to check on the hardware side?

Short explanation: I'm trying to fine adjust the toms; I had this separation problem with the Small Tom... Then I copied the parameters of input 6-7 to input 8-9 (except the note numbers) and used the same cable / trigger / tom (basically I moved TRS jack from in 6-7 to the next input) and I got good results.

TOM6-7.png

TOM8-9.png

Thank you!

[maru_engineering]

...and with Rim Threshold=120...

TOM6-7_Threshold120.png

[dmitri]

You have to fine tune MidPoint for best zone separation on a dual piezo/piezo pad.

[maru_engineering]

Hi Dmitri!

Already tried that...

TOM6-7_Treshold120_Head.png

[airflamesred]

Any reason why the crosstalk level is at 0?

[maru_engineering]

Hi Angr!

No, but I'm working on a single pad now, I didn't assemble the whole drum kit yet... But I thought if it's ok for the other input... Anyway, I will give it a shot...

Default is 4 for group 0, right?

[maru_engineering]

Yep, I was right...

TOM6-7_Treshold120_Head_XTalk.png

[dmitri]

You also have to make sure that HighLevel is set correctly for both zones. After that you have to adjust the MidPoint. How did you set HighLevels?

[maru_engineering]

As per instructions:

TOM6-7_Get_Levels.png

I left intentionally for the purpose of the screenshot the High Auto Levels to on, I want to cool down the Rim Piezo...

The point is that on the next input (8-9) with the same setting it is working fine... (of course, same pad, same trigger, same cable)...

[maru_engineering]

Maybe it's not clear in the picture because the initial events went away... I will redo...