Hi hat wiring

[airflamesred]

Refurbing this Alesis dm6
The hi hat is mono so fine.
The pedal seems to offer a variable resistance of 147 open and 0.1 closed.
It's mono so which pins do I wire this to?

Thanks

[airflamesred]

Bump

[ignotus]

I'd assume you'd wire it to tip and sleeve.

[airflamesred]

Cheers mate, so do I need pin 40 (pedal power)?
And either low or high impedance?

[ignotus]

If it's a mono jack I don't see how you can power it. I'd say it's low impedance if it just goes up to 147 ohms.

I'm not sure if the module requires there to be a voltage applied though, or if can just work with a varying resistance.

[airflamesred]

Well the module is now going to be MD so however they wired it will remain a mystery. I'm planning on running this in a DAW so do you think this could be adapted to change the value of CC4 for example.

[ignotus]

If MD can register the changes in pedal position then there's nothing stopping it from sending CC data.