www.megadrum.info

by **Synthex** » Mon Dec 17, 2007 8:00 am

Tyrell wrote:Ok, i see but clamp what range? Same as bat85 (30v i guess)? dont matter?

Schottky diode clamps VCC (5v) and GND (0v), 30v or 50v are maximum values.

by **Tyrell** » Tue Dec 18, 2007 1:44 am

thanks Synthex

by **cadman97** » Wed Dec 19, 2007 5:18 am

Synthex,

I am looking to etch a few boards based off your new design. what would be my next step. I downloaded diptrace.

thanks for the help.

Mike

by **dmitri** » Wed Dec 19, 2007 2:18 pm

If your question is about how to make PCBs then see this thread: viewtopic.php?f=3&t=90

by **Synthex** » Wed Dec 19, 2007 5:53 pm

l will post my PCB design bottom side soon ...

by **cadman97** » Wed Dec 19, 2007 6:36 pm

thanks synthx, that is what I was looking for

by **estregan** » Wed Dec 19, 2007 10:57 pm

Synthex wrote:l will post my PCB design bottom side soon ...

Will you include design for 22 input too?

by **Synthex** » Wed Dec 19, 2007 11:33 pm

I will include design for 22 input too.

by **cadman97** » Sun Dec 23, 2007 4:07 am

Synthex,

Any chance you might have the PCB bottom side design posted by the 26th?

Thanks for everything you have done.

Mike

by **Synthex** » Sun Dec 23, 2007 2:10 pm

cadman97 wrote:Any chance you might have the PCB bottom side design posted by the 26th?
Thanks for everything you have done.
Mike

Of course, regret for the delay, but I am still in my Christmas gifts !

PCB DESIGN - Digital with USB and Analog